Whirlpool Gas Oven Psh Code (2024)

FAQs

Whirlpool Gas Oven Psh Code? ›

OK PSH is not an error code it is telling you to push Start . If the start key is not pressed withing 5 seconds of programming a cycle you will see the PSH in the display .

Here is the answer to your PSH questionThe START pad begins any oven function. If the START pad is not pressed within 5 seconds after pressing a function pad, the 'Push to Start' (PSH) indicator light will flash and the push to start tone will sound as a reminder.

START TIME Delayed start The Start Time keypad is used to enter the starting time for an oven function with a delayed start. “PSH” appears in the display. If start is not pressed within 1 minute after pressing a keypad, the function is canceled and the time of day is displayed.

After setting your temp or broiler setting, the "P5H" is actually telling you to push the start button.

OK PSH is not an error code it is telling you to push Start . If the start key is not pressed withing 5 seconds of programming a cycle you will see the PSH in the display . You can also refer to page #8 in your use and care booklet also for this information. If you have any questions just let me know.

Control Board Failure

A shorted or faulty control board may be the cause of your oven's beeping noise. If the oven is beeping and won't stop, check for an error code on the unit's display. Make note of the error code so you can let your repair technician know the potential issue when you call for service.

To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute.

If you're getting beeping randomly without an error code, with your display control board is failing or the touchpad is failing. If the beeping is random, the touch pad would need to be replaced. If the beeping is evenly spaced out, you need to replace the control board.

Does Whirlpool have a reset button? ›

Locate the reset button, usually found beneath the status light on the control panel. Press and hold the button for three seconds or until you hear a beep or chirp. Once the appliance makes a noise, you can release the button and close your fridge.

To reset the washer's control panel:

If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the washer is hard-wired to the power supply, turn the breaker off at the home electrical panel that powers the washer for one minute and then turn the breaker back on.

A defective oven control panel can produce various symptoms affecting the appliance's performance. The control panel may be unresponsive, failing to register inputs or adjust oven mode and temperature settings. The display might show erratic readings or become entirely blank.

This occurs during preheat and periodically during cooking to maintain set temperature. If the oven indicator light flashes repeatedly or cycles on and off quickly, the flame was lost and cannot reignite. Turn oven selector bezel off. Reset unit's power at circuit breaker.

This indicates that the oven has been set to automatically turn on and off at a specified time. You will need to reset it if you want to use the oven in manual mode. Take a look at the specific instructions in the user manual for your oven to find out how to do this. Can't find it?

If an oven chimes or beeps unexpectedly:

Turn the power to the circuit breaker for the product off for 30 seconds, then turn it back on. Turn the unit back on and see if the beeping persists. Verify no other appliances or products are beeping such as the coffee maker, dishwasher, etc.

Try turning the breaker off to the unit for 60 seconds to see if it will reset. When you turn the circuit breaker on, go inside and push on the door. Hold it in for a minute or two in case it's rubbing on the door latch not allowing it to release. If that doesn't work, then try to set the self clean.